4 English reviews written for Slice engineering Copperhead Heat Break
13 customer reviews in all languages
| 5 stars | | 24 | (68%) |
|---|---|---|---|
| 4 stars | | 6 | (17%) |
| 3 stars | | 0 | (0%) |
| 2 stars | | 2 | (5%) |
| 1 Stars | | 3 | (8%) |
Filter reviews:
-
czaczaja
08 May 2023
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. -
EF
22 September 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Way to finnicky
Rated with 2 out of 5 stars.
I was allured by CNCKitchen video, thinking it was some kind of plug&play replacement. Had too many problems with the PTFE tube forming a gap that this seemed almost obvious. Oh boy I was tricked. Even with the boron nitride paste I wasn't able to prevent heat creep and the utter pain it's to clean when inevitably will clog is immense.
Was this rating helpful? (1) (0)
-
Willem Steenkamp
27 January 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. All Metal Hotend
Rated with 4 out of 5 stars.
The hotend itself works perfectly fine. Installation could be made easier by adding a way of tightening it with a spanner. Have too use pliers or vicegrip which damages it a little.
Was this rating helpful? (4) (0)
-
Evaldas
08 January 2022
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating. Suitable upgrade for Ender 3 V2
Rated with 5 out of 5 stars.
Got fed up with clogs on stock Ender 3 V2 heat break. Even after the washer fix, I couldn't print in confidence. Installed this (C-E version) today, have been printing all day and so far so good! Still need to try with something hotter than PLA, but I am sure it will perform miles better than stock.
Install was not too difficult, just be careful extracting your old heat break.Was this rating helpful? (1) (0)
Not for V2 Neo
Rated with 2 out of 5 stars.
This will not fit the 3 V2 NEO's Heatsink. The diameter is too thick. Waste or money
Was this rating helpful? (0) (0)