1 English review written for 3DJAKE Adheasy Spray
70 customer reviews in all languages
4,8 out of 5 stars
| 5 stars | | 140 | (86%) |
|---|---|---|---|
| 4 stars | | 14 | (8%) |
| 3 stars | | 5 | (3%) |
| 2 stars | | 1 | (0%) |
| 1 Stars | | 1 | (0%) |
Filter reviews:
-
Goran Visnjic, Slovenia
08 June 2024
"Verified Purchase" indicates that the rating was given by customers who actually bought this product from us. However, anyone who has a customer account with us can give a rating.
Very useful companion that should be beside every 3D printer
Rated with 5 out of 5 stars.
This was my first purchase of any build plate adhesion promotor. I was skeptical about this things and looked at them as another way to pull extra money from my wallet. If I used right build plate and right temperature, my prints always sticked pretty well to the build plate and were easily released after cool down.
Since it was relatively cheap and had good reviews I decided to give it a try. If anything, just out of curiosity.
Well, this thing works and works well. It supports laziness in some way, because it makes your selection of build plate surface material and build plate temperature less critical. In 90% cases with common materials, you do not have to tune your build plate temperature settings to be spot on.
It can be easily cleaned with methanol (maybe with other alcohols too, haven't tried).
Try not to spray it over your linear guides and other sliding elements if you spray directly on installed build plate, because it leaves thin layer of adhesive (as it is supposed to do), and you might run into problems after certain amount of careless spraying sessions.
Was this rating helpful? (0) (0)